Multiplex communication

Rear Door ECU LH Communication Stop

4steps
~24min
2/5difficulty
Done 0 of 4

DTC B1217 Rear Door ECU LH Communication Stop

DESCRIPTION

DTC B1217 is output when communication between the power slide door ECU LH and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.

DTC Detection Condition

Trouble Area

B1217

RL-DOOR ECU communication stops
  • Power slide door ECU LH
  • Wire harness

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - BATTERY)

CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - BATTERY)
  1. Disconnect the P25 and P26 ECU connectors.
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

2 CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - GROUND)

CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - GROUND)
  1. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

3 CHECK COMMUNICATION LINE

CHECK COMMUNICATION LINE
  1. Disconnect the G4 ECU connector.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Result

Result

REPLACE POWER SLIDE DOOR ECU LH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.