Toyota Sienna Quiz
Brake control

Removal

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read
1special tools

NOTICE:

  • Do not adjust the brake booster push rod.
  • Do not change the combination of the diameter converting unit and brake.

1. DRAIN BRAKE FLUID

NOTICE: Wash the brake fluid off immediately if it attaches to any painted surfaces.

2. SEPARATE BATTERY NEGATIVE TERMINAL

3. REMOVE AIR CLEANER ASSEMBLY WITH HOSE

4. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT (See page SP-13)

5. REMOVE BRAKE MASTER CYLINDER

REMOVE BRAKE MASTER CYLINDER

(a) Using SST, disconnect the 2 brake tubes from the brake master cylinder assembly.

SST 09023-00101

(b) Slide the clip and disconnect the brake master cylinder reservoir hose.

REMOVE BRAKE MASTER CYLINDER

(c) Remove the 2 nuts and brake master cylinder.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.