Toyota Sienna Quiz
Brake control

Reassembly

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read
1special tools

1. INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY

(a) Apply lithium soap base glycol grease to the 2 brake master cylinder union grommets and install them to the brake master less reservoir tank cylinder subassembly.

(b) Using a pin punch (φ 5 mm) and hammer, install the master cylinder union with the pin.

(c) Install the 2 new O-rings.

(d) Install the brake master less reservoir tank cylinder sub-assembly with the 2 nuts and, 2 bolts.

Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)

INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY

NOTICE: When the diameter converting unit and master cylinder are connected, install the No. 3 piston with no looseness.

INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY

(e) Using SST, install the brake tube to the brake master cylinder.

SST 09023-00101 Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)

(f) Install the new O-ring.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.