Toyota Sienna Quiz
Parking brake

Removal

In this manual: Parking brake
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. DISCONNECT BATTERY NEGATIVE TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE LH

3. REMOVE COWL SIDE TRIM BOARD LH

4. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH (See page IP-6)

5. REMOVE REAR DOOR SCUFF PLATE RH

6. REMOVE REAR DOOR SCUFF PLATE LH

7. REMOVE FRONT SEAT ASSEMBLY LH

HINT:

  • Manual Seat Type (See page SE-48)
  • Power Seat Type (See page SE-58)
  • Fold Flat Type (See page SE-40)

8. REMOVE REAR SEAT NO.1 ASSEMBLY

HINT:

  • Captain Seat Type (See page SE-68)
  • Center Seat Type (See page SE-77)

9. REMOVE REAR FLOOR SEAT LOCK COVER

10. REMOVE REAR FLOOR SEAT LOCK COVER

11. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Remove the 4 nuts and separate the instrument panel junction block assembly w/ wiring harness connector from the body.

(b) Disconnect the parking brake switch connector.

(c) Remove the bolt, 2 nuts and parking brake control pedal assembly.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.