Windshield / windowglass

Removal

2steps
~12min
1/5difficulty
Done 0 of 2

1. REMOVE BACK DOOR GARNISH CENTER

2. REMOVE BACK DOOR SIDE GARNISH LH

3. REMOVE BACK DOOR SIDE GARNISH RH

4. REMOVE BACK DOOR STRAP COVER

5. REMOVE BACK DOOR PULL STRAP

6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

7. REMOVE BACK DOOR SERVICE HOLE PLATE

8. REMOVE REAR SPOILER COVER (W/ REAR SPOILER)

9. REMOVE FRONT WIPER ARM HEAD CAP

10. REMOVE REAR WIPER ARM

11. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY

12. REMOVE BACK DOOR GLASS

REMOVE BACK DOOR GLASS
  1. Pass a piano wire between the body and glass from the interior.
    REMOVE BACK DOOR GLASS
  2. Tie both wire ends to wooden blocks or similar objects.

HINT: Apply protective tape to the outer surface to prevent the surface from being scratched.

NOTICE: When separating the glass, take care not to damage the paint and interior and exterior ornaments.
  • Cut off the adhesive by pulling piano wire around it.
  • Using a suction rubber, remove the glass.
  • NOTICE: Leave as much adhesive on the body as possible when removing the glass.

    13. CLEAN BACK DOOR GLASS

    CLEAN BACK DOOR GLASS
    1. Clean the outer circumference of the glass white gasoline.

    NOTICE:

    • Do not touch the glass surface after cleaning it.
    • Be careful not to damage the body.

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.