Back-up Light Switch
Inspection INSPECTION PROCEDURE
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below. Text in Illustration
Standard Resistance:
If the result is not as specified, replace the back-up light switch assembly. |
 |
1. REMOVE SHIFT LEVER BOOT ASSEMBLY
.gif)
2. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector. |
 |
(b) Detach the 4 clamps. |
 |
(c) Using SST, remove the back-up light switch assembly and gasket from the transmission case. SST: 09817-16011 |
 |
1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY
(a) Using SST, install a new gasket and the back-up light switch assembly to the transmission case. SST: 09817-16011 Torque: 44 N·m {449 kgf·cm, 32 ft·lbf} |
.png) |
(b) Attach the 4 clamps.
(c) Connect the connector.
2. INSTALL SHIFT LEVER BOOT ASSEMBLY
.gif)
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.