Manual Transmission Oil

1. INSPECT MANUAL TRANSMISSION OIL

(a) Park the vehicle on a level surface.

(b) Remove the transmission filler plug and gasket.

(c) Check that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the filler plug opening. Text in Illustration *a 0 to 5.0 mm (0 to 0.196 in.) If the result is not as specified, add transmission oil. Manual transmission oil: Oil grade Oil viscosity Standard capacity Gear oil API GL-3 (GL-4) SAE 75W-90 2.5 liters (2.6 US qts, 2.2 Imp. qts) NOTICE: Too much or too little oil will lead to transmission problems. After adjusting the oil level, drive the vehicle and check the oil level again.

(d) Inspect for oil leaks when the oil level is low.

(e) Install a new gasket and the transmission filler plug.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

1. DRAIN MANUAL TRANSMISSION OIL

(a) Remove the manual transmission filler plug and gasket.

(b) Remove the drain plug sub-assembly and gasket and then drain the manual transmission oil.

(c) Install a new gasket and the drain plug sub-assembly.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

2. ADD MANUAL TRANSMISSION OIL

(a) Add manual transmission oil until the oil level is within 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the manual transmission filler plug opening. Text in Illustration *a 0 to 5.0 mm (0 to 0.196 in.) Manual transmission oil: Oil grade Oil viscosity Standard capacity Gear oil API GL-3 (GL-4) SAE 75W-90 2.5 liters (2.6 US qts, 2.2 Imp. qts)

3. INSPECT MANUAL TRANSMISSION OIL