Toyota Tacoma Quiz
Rc62f Manual Transmission / Transaxle

Output Shaft

In this manual: Rc62f Manual Transmission / Transaxle
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
3special tools
Components COMPONENTS ILLUSTRATION Disassembly Disassembly DISASSEMBLY PROCEDURE

1. REMOVE FRONT OUTPUT SHAFT BEARING

(a) Temporarily install the manual transmission output shaft rear set nut to the output shaft.

Text in Illustration

*1

Manual Transmission Output Shaft Rear Set Nut

(b) Using SST and a press, remove the front output shaft bearing from the output shaft.

SST: 09316-60011

09316-00011

SST: 09950-00020

Inspection INSPECTION PROCEDURE

1. INSPECT OUTPUT SHAFT

(a) Using a cylinder gauge, measure the inside diameter of the output shaft.

Standard inside diameter:

45.009 to 45.025 mm (1.77201 to 1.7726 in.)

Maximum inside diameter:

45.025 mm (1.7726 in.)

If the diameter is more than the maximum, replace the output shaft.
Reassembly REASSEMBLY PROCEDURE

1. INSTALL FRONT OUTPUT SHAFT BEARING

(a) Using SST and a press, install a new front output shaft bearing to the output shaft.

SST: 09316-60011

09316-00011

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.