Clutch Pedal Switch
1. CHECK CLUTCH START SYSTEM
(a) Check that the engine does not start when the clutch pedal is released.
(b) Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.
Inspection INSPECTION PROCEDURE1. INSPECT CLUTCH START SWITCH ASSEMBLY
(a) Measure the resistance between the terminals when the switch is ON and OFF.
Switch Position | Specified Condition |
|---|---|
ON (pushed) |
Below 1 Ω |
OFF (free) |
10 kΩ or higher |
1. REMOVE CLUTCH START SWITCH ASSEMBLY
(a) Disconnect the clutch start switch assembly connector.
(b) Remove the nut and clutch start switch assembly from the clutch pedal support.
Installation INSTALLATION PROCEDURE1. INSTALL CLUTCH START SWITCH ASSEMBLY
(a) Install the clutch start switch assembly with the nut.
Torque:
16 N·m {160 kgf·cm, 12 ft·lbf}
(b) Connect the clutch start switch assembly connector.
2. INSPECT CLUTCH START SWITCH ASSEMBLY
.gif)
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.