Toyota Tacoma Quiz
Air Conditioning

Inspection

In this manual: Air Conditioning
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
INSPECTION PROCEDURE

1. INSPECT COOLER (ROOM TEMPERATURE. SENSOR) THERMISTOR

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(cooler thermistor (room temperature sensor))

*b

Sensing Portion

*c

Resistance (kΩ)

*d

Temperature (°C (°F))

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 - 2

10 °C

3.00 to 3.73 kΩ

15 °C

2.45 to 2.88 kΩ

20 °C

1.95 to 2.30 kΩ

25 °C

1.60 to 1.80 kΩ

30 °C

1.28 to 1.47 kΩ

35 °C

1.00 to 1.22 kΩ

40 °C

0.80 to 1.00 kΩ

45 °C

0.65 to 0.85 kΩ

50 °C

0.50 to 0.70 kΩ

55 °C

0.44 to 0.60 kΩ

60 °C

0.36 to 0.50 kΩ

NOTICE:

  • Hold the sensor only by its connector. Touching the sensing portion may change the resistance value.
  • When measuring, the sensor temperature must be the same as the ambient temperature.

If the result is not as specified, replace the cooler thermistor (room temperature sensor).

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.