Installation

1. INSTALL ENGINE WATER PUMP ASSEMBLY

(a) Install the engine water pump assembly and a new gasket to the timing chain cover assembly with the 15 bolts. Torque: for Bolt A and B : 11 N·m {112 kgf·cm, 8 ft·lbf} for Bolt C : 21 N·m {214 kgf·cm, 15 ft·lbf} for Bolt D : 43 N·m {438 kgf·cm, 32 ft·lbf} NOTICE: Be sure to apply adhesive to the 2 bolts labeled B before reusing them, or replace them with new ones if necessary. Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent Make sure that there is no oil on the threads of the bolts labeled C, D.

2. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

(a) Install the 2 No. 2 idler pulley sub-assemblies to the timing chain cover assembly with the 2 bolts.

Torque:

43 N·m {438 kgf·cm, 32 ft·lbf}

3. INSTALL VANE PUMP ASSEMBLY

(a) Install the vane pump assembly to the timing chain cover assembly with the 2 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

4. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

5. INSTALL COOLER COMPRESSOR ASSEMBLY

(See page )

6. INSTALL FAN SHROUD

7. INSTALL TRANSMISSION OIL COOLER HOSE (for Automatic Transmission)

(a) Engage the clamp to install the 2 transmission oil cooler hoses to the fan shroud.

8. CONNECT RADIATOR RESERVE TANK HOSE

9. INSTALL NO. 2 RADIATOR HOSE

10. INSTALL NO. 1 RADIATOR HOSE

11. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

(See page )