Toyota Tacoma Quiz
Cruise Control

Lost Communication with Vehicle Dynamics Control Module Missing Message (U012287)

In this manual: Cruise Control
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
DESCRIPTION

The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC No.

DTC Detection Condition

Trouble Area

MIL

Note

U012287

While cruise control main switch ON, communication stop between skid control ECU (brake actuator assembly) continues for 2.6 seconds or more
  • CAN communication system
  • ECM
  • Skid control ECU (brake actuator assembly)

Does not come on

SAE: U0122
CAUTION / NOTICE / HINT

HINT:

Refer to troubleshooting in CAN Communication System (See page PROCEDURE PROCEDURE ).

PROCEDURE

  1. CHECK FOR DTC

(a) Clear the DTCs (See page (b) Perform the following to make sure that the DTC detection conditions are ).

(b) Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

(1) Drive the vehicle at a speed for which cruise control operation is possible.

(2) Turn the cruise control system on using the cruise control main switch (ON/OFF).

(3) Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.

(c) Check the DTCs (See page OK: ).

OK:

DTC U012287 is not output

OK

USE SIMULATION METHOD TO CHECK
NG

GO TO CAN COMMUNICATION SYSTEM

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.