Washer Nozzle

Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT WASHER NOZZLE SUB-ASSEMBLY

(a) Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield glass in the areas shown in the illustration.

Text in Illustration

*a	Upper Limit	*b	Standard
*c	Lower Limit	*d	Vehicle center line
	Reference	-	-

HINT:

If the result is not as specified, replace the washer nozzle sub-assembly.

Adjustment ADJUSTMENT PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

(a) Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.

Text in Illustration

*a	Washer Fluid Spray Angle	*b	Part Number
*c	Identification Mark	-	-

3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

Installation INSTALLATION PROCEDURE

1. INSTALL WASHER NOZZLE SUB-ASSEMBLY

(a) Connect a new washer nozzle sub-assembly to the washer hose.

(b) Engage the 2 claws to install the washer nozzle sub-assembly as shown in the illustration.

2. INSPECT WASHER NOZZLE SUB-ASSEMBLY

3. ADJUST WASHER NOZZLE SUB-ASSEMBLY

Removal REMOVAL PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

HINT:

Use the same procedure for both sides.

(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to separate the washer nozzle sub-assembly as shown in the illustration. Text in Illustration *a Protective Tape NOTICE: Do not damage the windshield glass.

(b) Remove the washer nozzle sub-assembly from the washer hose. NOTICE: Washer nozzle sub-assembly cannot be reused.