Toyota Tacoma Quiz
Wiper / Washer

Washer Motor

In this manual: Wiper / Washer
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~2min read
010203040505.54N·mlb·ft
Tightening torque found on this page
Components COMPONENTS ILLUSTRATION On-vehicle Inspection On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

HINT:

This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.

(a) With the windshield washer motor and pump assembly installed to the washer jar, pour windshield washer fluid into the washer jar.

Text in Illustration

*a

Component without harness connected (Windshield Washer Motor and Pump Assembly)

(b) Check that the windshield washer fluid is pumped when battery voltage is applied to the terminals.

:

Condition

Specified Condition

Battery positive (+) → Terminal 1

Battery negative (-) → Terminal 2

Washer fluid is pumped

If the result is not as specified, replace the windshield washer motor and pump assembly.

Removal REMOVAL PROCEDURE

1. REMOVE HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side (See page 2. SEPARATE WASHER JAR ASSEMBLY ).

2. SEPARATE WASHER JAR ASSEMBLY

(a) Remove the 2 bolts to separate the washer jar assembly from the vehicle body.

3. DRAIN WINDSHIELD WASHER FLUID

(a) Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the windshield washer fluid.

HINT:

Use a container to collect the washer fluid.

4. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

(a) Disconnect the connector.

(b) Remove the windshield washer motor and pump assembly as shown in the illustration.

Installation INSTALLATION PROCEDURE

1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

(a) Install the windshield washer motor and pump assembly.

(b) Connect the washer hose.

(c) Connect the connector.

2. INSTALL WASHER JAR ASSEMBLY

(a) Install the windshield washer jar assembly with the 2 bolts in the order shown in the illustration.

Torque:

5,5 N·m {56 kgf·cm, 49 in·lbf}

3. ADD WASHER FLUID

(a) Add washer fluid to the washer jar assembly.

4. INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side. (See page Washer Nozzle )

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.