When the brake pedal is depressed, the stop light switch assembly sends a signal to the ECM. Upon receiving the signal, the ECM cancels the cruise control system.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P0571
Brake Switch "A" Circuit
When voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 seconds or more
Stop light switch assembly
ECM
Harness or connector
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the ECM, refer to Registration.
Click here
PROCEDURE
CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - BATTERY)
(a) Disconnect the stop light switch assembly connector.
*a
Front view of wire harness connector
(to Stop Light Switch Assembly)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
A4-2 - Body ground
Always
11 to 14 V
A4-4 - Body ground
Ignition switch ON
11 to 14 V
A4-4 - Body ground
Ignition switch off
Below 1 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Remove the stop light switch assembly.
Click here
(b) Inspect the stop light switch assembly.
Click here
NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK
CHECK HARNESS AND CONNECTOR (ECM - STOP LIGHT SWITCH ASSEMBLY)
(a) Disconnect the ECM connector.
*a
Front view of wire harness connector
(to ECM)
*1
for 1UR-FE
*2
for 3UR-FE
(b) Measure the voltage according to the value(s) in the table below.