Engine, Hybrid System
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FUEL SENDER GAUGE ASSEMBLY
2. REMOVE SUB TANK
(a) Disconnect the fuel pump connector. |
 |
(b) Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps. |
 |
(c) Disconnect the fuel tube. |
 |
(d) Using a screwdriver, detach the 3 claws from the claw holes.
HINT:
Tape the screwdriver tip before use. |
 |
(e) Using a screwdriver, detach the 2 claws from the claw holes and remove the sub tank.
HINT:
Tape the screwdriver tip before use.
NOTICE:
Do not damage the fuel sub tank. |
 |
3. REMOVE FUEL PUMP
(a) Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the suction plate with filter.
HINT:
Tape the screwdriver tip before use. |
 |
(b) Remove the fuel pump harness. |
 |
(c) Remove the O-ring and spacer from the fuel pump. |
 |
|
Was this page helpful?