Vehicle Interior
Headlight Dimmer Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HEADLIGHT DIMMER RELAY
(a) Remove the headlight dimmer relay from the engine room relay box.
(b) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3 - 5 |
Battery voltage not applied to terminals 1 and 2 |
10 kΩ or higher |
Battery voltage applied to terminals 1 and 2 |
Below 1 Ω |
3 - 4 |
Battery voltage not applied to terminals 1 and 2 |
Below 1 Ω |
Battery voltage applied to terminals 1 and 2 |
10 kΩ or higher |
If the result is not as specified, replace the headlight dimmer relay. |
 |
(c) Install the headlight dimmer relay to the engine room relay box. |
Was this page helpful?