Power Source, Network
How To Proceed With Troubleshooting
|
HINT:
- Use these procedures to troubleshoot the LIN communication system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
| NEXT |
 |
|
INSPECT BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
 |
|
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
(a) Using the Techstream, inspect the CAN communication function to ensure there are no malfunctions in the CAN communication system.
Click here 
Result | Proceed to |
No DTCs output |
A |
DTCs output |
B |
| A |
 |
|
CHECK FOR DTC*
(a) Check for DTCs.
Click here 
(b) Clear the DTCs.
Click here 
(c) Recheck for DTCs.
Click here 
Result | Proceed to |
DTC output does not reoccur |
A |
DTC output reoccurs |
B |
| A |
 |
|
PROBLEM SYMPTOMS TABLE
(a) Refer to the problem symptoms table.
Click here 
Result | Proceed to |
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
| B |
 |
GO TO STEP 6 |
| A |
 |
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Terminals of ECU
Click here 
(b) Data List / Active Test
Click here 
| NEXT |
 |
|
REPAIR OR REPLACE
| NEXT |
 |
END |
|
Was this page helpful?