Use the following procedures to troubleshoot the power door lock control system.
*: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
NEXT
CUSTOMER PROBLEM ANALYSIS CHECK
HINT:
In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points for problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time
Where
Whether the problem occurs at a specific location
Under what conditions?
Whether the doors were locked or unlocked, whether the ignition switch was ON, whether the engine has started
How did it happen?
Problem symptoms
NEXT
READ AND SAVE OPERATION HISTORY
NOTICE:
If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read out and saved, the operation history information could be lost.
The function "Read operation history" uses the current system time setting inside the Techstream and the time counter inside the controlling ECU to calculate the timings shown in the operation history. For this reason, before reading out the operation history, first make sure that the Techstream system clock is accurately set to the current time.
(a) Read and save operation history using the Techstream.
Click here
NEXT
INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
B
GO TO CAN COMMUNICATION SYSTEM
A
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
(a) Use the Techstream to check if the LIN communication system is functioning normally.
Click here
Result
Proceed to
LIN DTC is not output
A
LIN DTC is output
B
B
GO TO LIN COMMUNICATION SYSTEM
A
PROBLEM SYMPTOMS TABLE
(a) Refer to Problem Symptoms Table.
Click here
Result
Proceed to
Fault is not listed in Problem Symptoms Table (Fault can be simulated)
A
Fault is not listed in Problem Symptoms Table (Fault cannot be simulated)
B
Fault is listed in problem symptoms table
C
B
CHECK FOR INTERMITTENT PROBLEMS
C
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE