Engine, Hybrid System
Inspection
In this manual: Engine, Hybrid System
~1min read
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH
(a) As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.
Standard turning torque:
3.0 to 10.0 N*m (31 to 102 kgf*cm, 27 to 89 in.*lbf)
(c) Check for any cracks and grease leaks on the ball joint dust cover.
Was this page helpful?