Engine, Hybrid System
Reassembly
In this manual: Engine, Hybrid System
~1min read
4special tools
REASSEMBLY
PROCEDURE
1. INSTALL FRONT NO. 1 SPRING BUMPER LH
(a) Install the No. 1 spring bumper to the vehicle.
Torque:
31 N·m {316 kgf·cm, 23 ft·lbf}
2. INSTALL FRONT NO. 2 LOWER ARM LH
(a) Using SST and a press, press in a new bush.
SST: 09710-26011
09710-05081
NOTICE:
Press the bush while making sure the bush positioning protrusions are perpendicular to the lower arm, as shown in the illustration.
3. INSTALL FRONT NO. 1 LOWER ARM BUSH LH
(a) Using SST and a press, press in a new bush.
SST: 09223-00010
SST: 09612-30012
4. INSTALL FRONT LOWER BALL JOINT ATTACHMENT LH
(a) Install the attachment with the nut and a new cotter pin.
Torque:
167 N·m {1703 kgf·cm, 123 ft·lbf}
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
Was this page helpful?