Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR LOCK ASSEMBLY LH
(a) Check the door lock motor.
(1) Apply battery voltage to the door lock and check operation of the door lock.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
- If the result is not as specified, replace the door lock assembly.
(b) Check the door lock position switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Switch Condition | Specified Condition |
6 (LSSR) - 9 (E) |
Unlock |
Below 1 Ω |
Lock |
10 kΩ or higher |
- If the result is not as specified, replace the door lock assembly.
2. INSPECT REAR DOOR LOCK ASSEMBLY RH
(a) Check the door lock motor.
(1) Apply battery voltage to the door lock and check operation of the door lock.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
- If the result is not as specified, replace the door lock assembly.
(b) Check the door lock position switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Switch Condition | Specified Condition |
6 (LSSR) - 9 (E) |
Unlock |
Below 1 Ω |
Lock |
10 kΩ or higher |
- If the result is not as specified, replace the door lock assembly.
|
Was this page helpful?