Engine, Hybrid System

Installation

~1min read
0102030405043N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL COLUMN SHIFT ASSEMBLY

(a) Using a T30 "TORX" wrench, install the column shift with the 3 bolts.

Torque:

4 N·m {41 kgf·cm, 35 in·lbf}

(b) Connect the connector and attach the harness clamp.

(c) Connect the column shift transmission control cable end to the column shift.

NOTICE:

Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.

2. ADJUST SHIFT LEVER POSITION

3. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

(See page )

4. INSPECT SHIFT LEVER POSITION