Power Mirror cannot be Adjusted with Power Mirror Switch
In this manual: Vehicle Interior
~3min read
DESCRIPTION
When the outer mirror switch assembly (mirror master switch) is operated, right/left selection signals are sent to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) sends the received right/left selection signals to the outer mirror control ECU assemblies via CAN communication.
WIRING DIAGRAM
NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.
Click here
PROCEDURE
READ VALUE USING TECHSTREAM (OUTER MIRROR SWITCH ASSEMBLY)
(a) Using the Techstream, read the Data List.
Click here
Main Body
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Mirror Selection SW (R)
Mirror master switch signal for RH mirror / ON or OFF
ON: Mirror master switch is in R position
OFF: Mirror master switch is OFF or in L position
-
Mirror Selection SW (L)
Mirror master switch signal for LH mirror / OFF or ON
ON: Mirror master switch is in L position
OFF: Mirror master switch is OFF or in R position
-
Mirror Position SW (R)
Mirror control switch signal (Right) / OFF or ON
ON: RIGHT switch is ON
OFF: Any switch except RIGHT is ON or all switches are OFF
-
Mirror Position SW (L)
Mirror control switch signal (Right) / OFF or ON
ON: LEFT switch is ON
OFF: Any switch except LEFT is ON or all switches are OFF
-
Mirror Position SW (Up)
Mirror control switch signal (Up) / OFF or ON
ON: UP switch is ON
OFF: Any switch except UP is ON or all switches are OFF
-
Mirror Position SW (Dwn)
Mirror control switch signal (Down) / OFF or ON
ON: DOWN switch is ON
OFF: Any switch except DOWN is ON or all switches are OFF
-
OK:
The display is as specified in the normal condition column.
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
NG
INSPECT OUTER MIRROR SWITCH ASSEMBLY
(a) Remove the outer mirror switch assembly.
Click here
(b) Inspect the outer mirror switch assembly.
Click here
NG
REPLACE OUTER MIRROR SWITCH ASSEMBLY
OK
CHECK HARNESS AND CONNECTOR (OUTER MIRROR SWITCH ASSEMBLY - MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
(a) Disconnect the J131 outer mirror switch assembly connector.
(b) Disconnect the J164 main body ECU (multiplex network body ECU) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
J131-3 (M+) - J164-4 (MIRB)
Always
Below 1 Ω
J131-1 (MSW) - J164-5 (MIRS)
Always
Below 1 Ω
J131-2 (E) - J164-6 (MIRE)
Always
Below 1 Ω
J131-3 (M+) or J164-4 (MIRB) - Body ground
Always
10 kΩ or higher
J131-1 (MSW) or J164-5 (MIRS) - Body ground
Always
10 kΩ or higher
J131-2 (E) or J164-6 (MIRE) - Body ground
Always
10 kΩ or higher
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)