Audio, Visual, Telematics

Radio Antenna Pole

~1min read
010203040503.32N·mlb·ft
Tightening torque found on this page

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

PROCEDURE

1. INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY

(a) Install the pull top antenna pole sub-assembly and tighten it by hand until it is fully seated.

(b) Using an 8 mm (0.315 in.) wrench or antenna mast tool, tighten the pull top antenna pole sub-assembly clockwise approximately 1/8 turn (20 to 45 degrees).

HINT:

  • Do not overtighten the pull top antenna pole sub-assembly. Tighten the pull top antenna pole sub-assembly with your fingers, not your whole hand.
  • Do not use pliers to tighten the pull top antenna pole sub-assembly as it can leave marks on the pull top antenna pole sub-assembly surface.
  • The pull top antenna pole sub-assembly cannot be tightened by hand to the proper torque specification.

Torque:

3,3 N·m {3.4 kgf·cm, 29 in·lbf}

Removal

REMOVAL

PROCEDURE

1. REMOVE PULL TOP ANTENNA POLE SUB-ASSEMBLY

(a) Using an 8 mm (0.315 in.) wrench or antenna mast tool, remove the pull top antenna pole sub-assembly by turning it counterclockwise.