Audio, Visual, Telematics

Rear Door Speaker(for Double Cab)

~2min read

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for Standard)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

3.2 to 4.8 Ω

If the result is not as specified, replace the rear No. 1 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Rear No. 1 Speaker Assembly)

2. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for 7 Speakers)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

2 Ω

If the result is not as specified, replace the rear No. 1 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Rear No. 1 Speaker Assembly)

Installation

INSTALLATION

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY

(a) Connect the connector.

Text in Illustration

*A

for Standard

*B

for 7 Speakers

(b) Install the rear No. 1 speaker assembly with the 3 screws.

NOTICE:

Do not touch the cone part of the speaker.

HINT:

Install the screws in the order shown in the illustration.

2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL REAR DOOR ARMREST COVER LH

4. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

6. INSTALL REAR DOOR FRAME GARNISH LH

Removal

REMOVAL

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR DOOR FRAME GARNISH LH

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

4. REMOVE REAR DOOR ARMREST COVER LH

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE REAR NO. 1 SPEAKER ASSEMBLY

(a) Remove the 3 screws.

Text in Illustration

*A

for Standard

*B

for 7 Speakers

NOTICE:

Do not touch the cone part of the speaker.

(b) Disconnect the connector and remove the rear No. 1 speaker assembly.