Toyota Venza Quiz
Navigation / Multi Info Display

CD Sound Skips

In this manual: Navigation / Multi Info Display
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
PROCEDURE

  1. CHECK CD

(a) Check that the CD is not deformed or cracked.

OK:

No deformation or cracks on the CD.

NG

END (CD IS FAULTY)
OK

  1. CHECK CD

(a) Check the CD.

OK:

The CD is clean.

NOTICE:

Do not use a conventional record cleaner or anti-static preservative.

HINT:

If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NG

CLEAN CD
OK

  1. REPLACE CD AND RECHECK

(a) Replace the CD with a new or known good one and check that the malfunction disappears.

OK:

Malfunction disappears.


OK

END (CD WAS FAULTY)
NG

  1. CHECK NAVIGATION RECEIVER ASSEMBLY

(a) Check the navigation receiver assembly installation condition.

(1) Check that the navigation receiver assembly is properly installed.

OK:

The navigation receiver assembly is properly installed.


OK

REPLACE NAVIGATION RECEIVER ASSEMBLY

NG

REINSTALL NAVIGATION RECEIVER ASSEMBLY

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.