Window / Glass
Inspection
INSPECTION PROCEDURE
1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH)
(a) Check the switch function.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
6 (UP) - 1 (GND) |
Auto up or up position |
Below 1 Ω |
7 (DOWN) - 1 (GND) |
Auto down or down position |
Below 1 Ω |
8 (AUTO) - 1 (GND) |
Auto up or auto down position |
Below 1 Ω |
6 (UP) - 1 (GND) |
Free |
10 kΩ or higher |
7 (DOWN) - 1 (GND) |
Free |
10 kΩ or higher |
8 (AUTO) - 1 (GND) |
Free |
10 kΩ or higher |
Text in Illustration
*1 |
Component without harness connected
(to Power Window Regulator Switch Assembly (for Rear LH Side)) |
If the result is not as specified, replace the power window regulator switch assembly (for rear LH side). |
.png) |
(b) Check that the LED illuminates.
(1) Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → 4 (LED)
Battery negative (-) → 1 (GND) |
LED illuminates |
Text in Illustration
*1 |
Component without harness connected
(to Power Window Regulator Switch Assembly (for Rear LH Side)) |
If the result is not as specified, replace the power window regulator switch assembly (for rear LH side). |
.png) |
2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear RH)
(a) Check the switch function.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
6 (UP) - 1 (GND) |
Auto up or up position |
Below 1 Ω |
7 (DOWN) - 1 (GND) |
Auto down or down position |
Below 1 Ω |
8 (AUTO) - 1 (GND) |
Auto up or auto down position |
Below 1 Ω |
6 (UP) - 1 (GND) |
Free |
10 kΩ or higher |
7 (DOWN) - 1 (GND) |
Free |
10 kΩ or higher |
8 (AUTO) - 1 (GND) |
Free |
10 kΩ or higher |
Text in Illustration
*1 |
Component without harness connected
(to Power Window Regulator Switch Assembly (for Rear RH Side)) |
If the result is not as specified, replace the power window regulator switch assembly (for rear RH side). |
|
(b) Check that the LED illuminates.
(1) Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → 4 (LED)
Battery negative (-) → 1 (GND) |
LED illuminates |
Text in Illustration
*1 |
Component without harness connected
(to Power Window Regulator Switch Assembly (for Rear RH Side)) |
If the result is not as specified, replace the power window regulator switch assembly (for rear RH side). |
|
?
Test yourself
A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?