Installation

INSTALLATION PROCEDURE

1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

(a) Apply a light coat of gasoline or spindle oil to a new O-ring. Text in Illustration *1 O-ring

(b) Install the O-ring to the fuel pressure pulsation damper assembly.

(c) Install the fuel pressure pulsation damper assembly with the 2 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the damper.

2. INSTALL FUEL TUBE SUB-ASSEMBLY

Text in Illustration

*1	No. 2 Fuel Pipe Clamp
*2	Fuel Hose Clamp
	Push

(a) Connect the fuel tube.

(b) Push the fuel tube connector until it makes a "click" sound.

(c) Install a new No. 2 fuel pipe clamp.

(d) Push the tube connector into the pipe until the tube connector makes a "click" sound.

Text in Illustration

*1	Fuel Pipe
*2	Fuel Tube Connector
*3	Nylon Tube
*4	O-ring
*5	Retainer
	Push

NOTICE:

• Before connecting the connector and fuel pipe, check that there is no damage or foreign matter on the connecting part of the fuel pipe.
• After connecting the fuel tube connector and fuel pipe, check that they are securely connected by trying to pull them apart.

(e) Install the No. 1 fuel pipe clamp.

(f) Install the fuel tube sub-assembly to the fuel hose clamp.

3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

4. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

6. INSTALL OUTER COWL TOP PANEL

7. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Install the windshield wiper motor and link assembly (See page ).

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

9. INSPECT FOR FUEL LEAK