Installation

1. INSTALL GENERATOR ASSEMBLY

(a) Install the generator with the 2 bolts. Torque: 52 N·m {530 kgf·cm, 38 ft·lbf}

(b) Install the wire harness clamp bracket with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf}

(c) Connect the generator wire with the nut.

Torque:

9,8 N·m {100 kgf·cm, 87 in·lbf}

(d) Install the terminal cap.

(e) Connect the generator connector.

2. INSTALL WIRE HARNESS CLAMP BRACKET

(a) Install the clamp bracket with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf}

(b) Attach the wire harness clamp to the clamp bracket.

3. INSTALL V-RIBBED BELT

HINT:

See page

4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

5. INSTALL COOL AIR INTAKE DUCT SEAL

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).