Toyota Venza: Installation

INSTALLATION PROCEDURE

1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Install the rear wiper motor and bracket assembly with the 3 bolts.

Torque:

5,5 N·m {56 kgf·cm, 49 in·lbf}

(b) Connect the connector.

2. INSTALL REAR WIPER MOTOR GROMMET

(a) Apply MP grease to the entire surface of the wiper motor grommet lip.

Text in Illustration

MP grease

HINT:

Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

(b) Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Stop the wiper motor at the automatic stop position.

(b) When reusing the rear wiper arm and blade assembly:

(1) Clean the wiper arm serrations.

Text in Illustration

*1	Wiper Arm Serration

(1) Clean the wiper pivot serrations with a wire brush.

Text in Illustration

*1	Wire Brush
*2	Wiper Pivot Serration

(d) Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

Standard Measurement

Area	Dimension
A	7.5 mm (0.295 in.)

Text in Illustration

*1	Ceramic Hard Line

Torque:

5,5 N·m {56 kgf·cm, 49 in·lbf}

(e) Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

4. INSTALL REAR WIPER ARM HEAD CAP

(a) Engage the 4 claws to install the cap as shown in the illustration.

5. INSTALL BACK DOOR PANEL TRIM ASSEMBLY

Installation

Test yourself