Washer Level Warning Switch

1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:

The following check should be performed with the windshield washer motor and pump installed to the washer jar.

(a) Fill the washer jar with washer fluid.

(b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (S) - 2 (E) Fluid volume is more than 700 to 900 ml 10 kΩ or higher 1 (S) - 2 (E) Fluid volume is less than 700 to 900 ml Below 1 Ω If the result is not as specified, replace the level warning switch assembly. Text in Illustration *1 Component without harness connected (Level Warning Switch Assembly)

1. REMOVE FRONT WHEEL RH

2. REMOVE FRONT FENDER OUTSIDE MOULDING RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

3. REMOVE FRONT FENDER LINER RH

4. DRAIN WINDSHIELD WASHER FLUID

5. REMOVE WASHER LEVEL WARNING SWITCH ASSEMBLY

(a) Disconnect the connector.

(b) Remove the washer level warning switch assembly.

1. INSTALL WASHER LEVEL WARNING SWITCH ASSEMBLY

(a) Install the washer level warning switch assembly.

(b) Connect the connector.

(c) Connect the washer hose.

2. FILL WASHER JAR WITH WASHER FLUID

3. INSTALL FRONT FENDER LINER RH

4. INSTALL FRONT FENDER OUTSIDE MOULDING RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

5. INSTALL FRONT WHEEL RH