Toyota Venza Quiz
Axle And Differential

Installation

In this manual: Axle And Differential
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
03060901201508059N·mlb·ft
Tightening torque found on this page
INSTALLATION CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure listed below is for the LH side.
PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the parking brake assembly and the rear axle hub and bearing assembly with the 4 bolts.

Torque:

80 N·m {816 kgf·cm, 59 ft·lbf}

NOTICE:

Do not twist the No. 3 parking brake cable assembly when installing it.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS


3. INSPECT REAR AXLE HUB RUNOUT


4. INSTALL REAR SPEED SENSOR WIRE


5. INSTALL REAR DISC


6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


7. INSTALL REAR FLEXIBLE HOSE


8. INSTALL REAR WHEEL

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}

9. CHECK FOR SPEED SENSOR SIGNAL

(a) Check for the speed sensor signal (See page ).

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.