Removal

REMOVAL PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

6. REMOVE REAR DOOR FRAME GARNISH

7. REMOVE REAR DOOR SERVICE HOLE COVER

8. REMOVE REAR DOOR CHECK ASSEMBLY

9. REMOVE REAR DOOR WEATHERSTRIP

10. REMOVE REAR DOOR GLASS RUN

11. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

13. REMOVE REAR DOOR OUTSIDE STRIPE

(a) Using a heat light, heat the rear door outside stripe and vehicle body.

Heating Temperature

Item	Temperature
Vehicle Body	40 to 60 °C

NOTICE:

Do not heat the vehicle body excessively.

(b) Pull back on one of the ends of the rear door outside stripe to remove it. HINT: When pulling on the tape, pull it parallel to the body.

14. REMOVE REAR DOOR LOWER OUTSIDE STRIPE

(a) Using a heat light, heat the rear door lower outside stripe and vehicle body.

Heating Temperature

Item	Temperature
Vehicle Body	40 to 60 °C

NOTICE:

Do not heat the vehicle body excessively.

(b) Pull back on one of the ends of the rear door lower outside stripe to remove it. HINT: When pulling on the tape, pull it parallel to the body.

15. REMOVE NO. 2 BLACK OUT TAPE

(a) Using a heat light, heat the No. 2 black out tape and vehicle body.

Heating Temperature

Item	Temperature
Vehicle Body	40 to 60 °C

NOTICE:

Do not heat the vehicle body excessively.

(b) Pull back on one of the ends of the No. 2 black out tape to remove it. HINT: When pulling on the tape, pull it parallel to the body.