Toyota Venza Quiz
Exterior Panels / Trim

Removal

In this manual: Exterior Panels / Trim
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL PROCEDURE

1. REMOVE COOL AIR INTAKE DUCT SEAL

(a) Using a clip remover, remove the 12 clips and cool air intake duct seal.

2. REMOVE RADIATOR GRILLE


3. REMOVE FRONT BUMPER ASSEMBLY

(a) Put protective tape around the front bumper assembly.

Text in Illustration

*1

Protective Tape

(b) Remove the 2 bolts and 6 screws.

(c) Using a clip remover, remove the clip.

(d) Remove the screw.

HINT:

Use the same procedure for the RH side and LH side.

(e) Using a screwdriver, turn the 2 pins 90 degrees and remove the 2 pin hold clips.

HINT:

Use the same procedure for the RH side and LH side.

(f) Disengage the 4 claws and remove the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.

(g) Disconnect each connector.

(h) Remove the front bumper assembly as shown in the illustration.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.