Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

5. REMOVE COURTESY LIGHT ASSEMBLY

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

7. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

8. REMOVE DOOR SIDE AIRBAG SENSOR

9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

10. REMOVE FRONT DOOR SERVICE HOLE COVER

11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

12. REMOVE FRONT DOOR GLASS RUN

13. REMOVE FRONT DOOR BELT MOULDING

(a) Put protective tape around the front door belt moulding. Text in Illustration *1 Protective Tape

(b) Using a clip remover, remove the clip.

(c) Using a screwdriver, disengage the 5 claws and remove the front door belt moulding.