Removal
1. REMOVE FRONT WIPER ARM HEAD CAP
(a) Using a screwdriver, remove the 2 front wiper arm head caps as shown in the illustration. Text in Illustration
HINT: Tape the screwdriver tip before use. |
 |
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
(a) Remove the nut and the front wiper arm and blade assembly LH. |
 |
3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
(a) Remove the nut and the front wiper arm and blade assembly RH. |
 |
4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
(a) Disengage the claw and 2 guides and remove the front fender to cowl side seal LH. |
 |
5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
HINT:
Use the same procedure for the RH side and LH side.
6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
(a) Using a clip remover, remove the 2 clips. |
 |
(b) Disengage the 13 claws and pull out the cowl top ventilator louver sub-assembly as shown in the illustration. |
 |
7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(a) Disconnect the connector. |
 |
(b) Remove the 3 bolts and the windshield wiper motor and link assembly as shown in the illustration. |
 |
8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Using a screwdriver, disengage the windshield wiper link rod from the crank arm pivot of the front wiper motor assembly as shown in the illustration. Text in Illustration
HINT: Tape the screwdriver tip before use. |
 |
(b) Using a T30 "TORX" socket wrench, remove the 2 bolts and the windshield wiper motor assembly from the windshield wiper link assembly. |
 |
Test yourself
A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.