Toyota Venza Quiz
Seat

Removal

In this manual: Seat
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~2min read
REMOVAL PROCEDURE

1. REMOVE REAR SEAT HEADREST ASSEMBLY

(a) Press the headrest support button and pull up the rear seat headrest assembly as shown in the illustration.

2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

(a) Press the headrest support button and pull up the rear seat center headrest assembly as shown in the illustration.

3. REMOVE REAR SEAT INNER TRACK BRACKET COVER

(a) Disengage the 3 claws and guide, and remove the rear seat inner track bracket cover as shown in the illustration.

4. REMOVE REAR SEAT OUTER TRACK BRACKET COVER

(a) Disengage the 3 claws and guide, and remove the rear seat outer track bracket cover as shown in the illustration.

5. DISCONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY

(a) Pull down the adjuster's lock piece to release the lock as shown in the illustration.

Text in Illustration

*1

Adjuster Spring

*2

Lock Piece

(b) Using a screwdriver wrapped with protective tape, disengage the 2 claws as shown in the illustration.

Text in Illustration

*1

Protective Tape

(c) Lift up the seat track adjusting handle to the uppermost position and hold the handle in this position as shown in the illustration.

Text in Illustration

*1

Protective Tape

*2

Seat Track Adjusting Handle

(d) Using a screwdriver wrapped with protective tape, disconnect the rear seat reclining control cable sub-assembly as shown in the illustration.

Text in Illustration

*1

Protective Tape

6. REMOVE REAR SEAT ASSEMBLY RH

(a) Remove the 3 bolts on the rear side of the seat.

(b) Remove the 2 bolts on the front side of the rear seat assembly RH.

(c) Remove the rear seat assembly RH.

NOTICE:

Be careful not to damage the vehicle body.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.