Volkswagen Golf Quiz
General body repairs, interior

Removing and installing eyelet for net partition

In this manual: General body repairs, interior
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Special tools and workshop equipment required

Removal wedge -3409-
Removal wedge -3409-

Removing

Eyelet for net partition, without rear reading light

Note Removal and installation is described for the rear left eyelet for net partition. Follow same instructions for the remaining eyelets for net partition as appropriate.
  • Remove bolt -2-.
  • Release trim -1- with eyelet for net partition at bottom from moulded headliner using removal wedge -3409--arrow A-.
  • Then, slightly guide trim -1- with eyelet for net partition downwards out of moulded headliner -arrow B-.
  • After that, guide eyelet for net partition with trim upwards out of moulded headliner, and remove it.
Note On vehicles with sliding sunroof, the retaining lugs on the rear trims -1- are reverted by 180°. The removal and installation procedure for these eyelets for net partition must be adapted accordingly.
Removing and installing eyelet for net partition

Eyelet for net partition, with rear reading light

Note Removal and installation is described for the left eyelet for net partition. Follow same instructions for the right eyelet for net partition as appropriate.
  • Remove rear left reading light -W11- → Electrical system; Rep. gr.96.
  • Remove bolt -2-.
  • Release retaining lugs -3- on trim -1-, and release trim from moulded headliner using removal wedge -3409--arrow A-.
  • Then, slightly guide trim -1- with eyelet for net partition towards front out of moulded headliner -arrow B-.
Removing and installing eyelet for net partition

Installing

Install in reverse order, but note the following:

Note Ensure that the locating lug -arrow- on the bracket for net partition is properly seated in the recess in the eyelet for net partition -1-.

Specified torques

→ Chapter „Assembly overview- net partition“
Removing and installing eyelet for net partition

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.