Volkswagen Golf Quiz
Heating, air conditioning

Removing and installing refrigerant line between condenser and evaporator

In this manual: Heating, air conditioning
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
0204060801005037N·mlb·ft
Tightening torque found on this page

Special tools and workshop equipment required

Engine bung set -VAS 6122
Engine bung set -VAS 6122

Torque wrench -V.A.G 1331/- (5…50 N·m)

Air conditioner service station

Removing

  • Observe safety precautions → Chapter „Safety precautions when handling refrigerants“.
  • Comply with notes → Chapter „Working on refrigerant circuit“.
  • Extract refrigerant using air conditioner service station before opening refrigerant circuit.
  • Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
  • Remove right engine mounting → Rep. gr.10.
Risk of freezing injury caused by escaping pressurised refrigerant.There is a risk of injury to the skin and parts of the body due to freezing.Always wear safety gloves.Always wear safety goggles.Extract refrigerant, and open the refrigerant circuit immediately afterwards.If more than 10 minutes passed since the refrigerant has been extracted, do not open the refrigerant circuit prior to extracting refrigerant anew. Due to re-evaporation, pressure will be built up in the refrigerant circuit.
Removing and installing refrigerant line between condenser and evaporator
  • Unscrew nut -1-.
  • Separate refrigerant lines.
Removing and installing refrigerant line between condenser and evaporator
  • Unscrew bolt -5- of lower refrigerant line -3-.
  • Remove refrigerant line -3- from condenser -1-.
  • Unclip refrigerant line -3- from retainers, and remove it.

Installing

Installation is carried out in the reverse order. When installing, note the following:
  • Renew seals. For versions, refer to → Electronic Parts Catalogue.
  • Moisten seals with refrigerant oil before installing → Chapter.
Note Ensure proper seating of seals in the groove of the respective refrigerant line.

Specified torques

→ Chapter „System overview - refrigerant circuit“.

Assembly overview - assembly mountings → Rep. gr.10

Front bumper cover → General body repairs, exterior; Rep. gr.63
Removing and installing refrigerant line between condenser and evaporator

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.