Volkswagen Golf Quiz
Running gear, axles, steering

Removing and installing upper transverse link, front-wheel drive

In this manual: Running gear, axles, steering
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Special tools and workshop equipment required

Torque wrench -V.A.G 1332-

Removing

  • Loosen wheel bolts.
  • Raise vehicle.
  • Remove wheel.
  • Remove spring → Chapter.
Removing and installing upper transverse link, front-wheel drive
  • Unhook line -1- from retainer -2--arrows-.
  • Unscrew nut -3- and remove washer -4-.
  • Pull out bolt -5-.
  • Use felt-tip pen or similar to mark position of eccentric bolt -3- in relation to subframe.
Removing and installing upper transverse link, front-wheel drive
  • Unscrew nut -2- and pull out eccentric bolt -3-.
  • Take out upper transverse link -1-.

Installing

Install in reverse order of removal, observing the following:

The threaded connections of the suspension link may only be loosened and tightened in the unladen weight position → Chapter.
  • Perform wheel alignment → Chapter.

Specified torques

→ Chapter „Assembly overview - transverse link“

→ Chapter „Torque settings for wheel bolts“
Removing and installing upper transverse link, front-wheel drive

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.