Two-Part IR Premium Filling Paste

Part names:

Two-Part IR Premium Filling Paste -LSP 787 220 A1-

Two-Part IR Premium Filling Paste -LSP 787 220 A2-

Two-Part IR Premium Filling Paste -LSP 787 220 A3-

Edition 06/2011

Product Description

Other Application Areas:

All conventional metallic base surfaces

Also adheres very well to galvanized base surfaces.

Sands well

Non-porous and easily-shapeable.

Well-suited for IR drying

Application Instructions

Base Surface

Suitable base surfaces:

Steel Panel

Galvanized sheet steel

Aluminum

Well-sanded factory or old paint

Hardened and sealed two-part filler/two-part primers

Cleaned and sanded UP-GF surfaces, free of separating agents

Caution This filling paste may not be applied to PVB (acid-hardening) adhesive primers or one-part primers (for example, synthetic resin). Application on thermoplastic or elastic coatings is also not possible.

Pre-treatment of base surfaces:

• Remove any grease and sand the surface.
• Bare metallic base surfaces are to be insulated with Two-Part Wash Primer -LHV 043 000 A2- and then filled with Two-Part HS Performance Filler. Sand the filler after drying.
• With UP-GF underbodies, clean components of any residual agents and sand the surface.
• Before reworking, apply a suitable cleaning agent to all base surfaces to ensure a clean and residue-free surface.

Processing

Application type:

• Apply filling paste.

Mixture ratio:

• Add 2 to 3 % by weight Two-Part Hardener -LVM 018 000 A1/A2- or, especially when dealing with high temperatures, Two-Part Hardener, Long -LVM 018 100 A2-.

Note

Curing Time:

• At +20 °C room temperature for approximately two to four minutes.

Reaction Temperature:

• Minimum +5 °C

Drying

Air Drying:

• At +20 °C room temperature for about 20 to 30 minutes.

Infrared drying:

Short-wave heaters for three minutes (at 50 % power)

Medium-wave heaters for five minutes.

Sanding compatibility

In connection with the aforementioned drying time:

• Dry-sand the pre-sanding with P80-240 grit sandpaper
• Dry-sand the final sanding with P240-400 grit sandpaper

Temperature resistance up to +80 °C.

Reworking

Recommended structure:

Fine filling paste by itself.

• Then paint over with the top coat.

Note

Before filling, dry-sand the entire surface with P280-400 sandpaper.

Personal Protective Equipment:

Note the safety data sheets

Wear the personal protective equipment during application

Characteristics

Storage

Storage Conditions

• Storage Temperature +20 °C (temperature should not exceed +30 °C).