Transmission, Transporting

Transmission, Transporting

Special tools and workshop equipment required

• Transmission Support Jig -3336-
• Shop Crane -VAS6100-

• Attach the Transmission Support Jig -3336- to the clutch housing.

• Move the support arm on the sliding bar using the locking bolt -arrow-.

Number of visible holes = 6.

• Lift the transmission with a workshop crane and the Transmission Support Jig -3336-.
• Set the transmission down, for example, into the transport container.

Transmission Fluid

Transmission Fluid Level, Checking

Special tools and workshop equipment required

• For oil filler plug with multi-point fitting Triple Square Socket Driver -3357-.
• Torque Wrench 1331 5-50Nm -VAG1331-

Transmission fluid. Refer to the Parts Catalog.

• Remove the noise insulation.
• Remove the plug for checking the transmission fluid level -arrow-.

The Level Is Correct When the Transmission Fluid Comes up to the Bottom Edge of Oil Filler Hole.

• Add transmission fluid, if necessary, until it reaches the lower edge of the filler hole.
• If present with new seal, install bolt -arrow-.
• Tighten the bolt -arrow-.

Different Versions of Fluid Fill and Drain Plugs

I - Fluid fill or drain plug with internal multi-point, 45 N·m

II - Fluid fill or drain plug with inner hex socket, 35 N·m

• Install the noise insulation.

Securing on Engine and Transmission Holder

Manual Transmission, Securing on Engine and Transmission Holder

Special tools and workshop equipment required

• Holding Fixture -VW313-
• Holding Plate -VW309A-
• or Holding Plate -VW309A-
• Transmission Support -VW353-

• Secure the transmission on the Transmission Support -VW353--arrows-.
• Place the Drip Tray -VAS6208- underneath.

Note

If one of the fastening holes does not touch the Transmission Support -VW353-, place washers between the fastening hole and the Transmission Support -VW353-.