Self Help
Sealing and inflating the tire
In this manual: Self Help
~2min read
and safety warnings first⇒
to sealing a tire
- Unscrew the valve cap from the tire valve.
- Using the valve core tool ⇒ Fig. 156① unscrew the valve core from the tire valve and place it on a clean surface.
- Shake the tire sealant bottle ⇒ Fig. 156⑩ vigorously several times.
- Screw the filler hose ⇒ Fig. 156③ firmly onto the tire sealant bottle in a clockwise direction. The foil on the cap is pierced automatically.
- Remove the sealing plug from the filler hose ⇒ Fig. 156③ and push the open end fully onto the tire valve.
- Hold the bottle with the bottom facing up and fill the entire contents of the tire sealant bottle into the tire.
- Remove the empty tire sealant bottle from the valve.
- Screw the valve core back into the tire valve using the valve core tool ⇒ Fig. 156①.
- Screw the tire inflation hose ⇒ Fig. 156⑤ of the air compressor firmly onto the tire valve.
- Check that the air release screw ⇒ Fig. 156⑦ is closed.
- Start the vehicle engine and let it run.
- Plug the cable connector ⇒ Fig. 156⑨ into a 12-volt socket in the vehicle ⇒ Sockets.
- Switch on the air compressor using the ON/OFF switch ⇒ Fig. 156⑧.
- Let the air compressor run until 2.0 – 2.5 bar (29 – 36 psi / 200 – 250 kPa) is reached ⇒
.
Maximum run time 8 minutes⇒
.
- Switch off the air compressor.
- If the tire pressure of 2.0 – 2.5 bar (29 – 36 psi / 200 – 250 kPa) cannot be reached, unscrew the tire inflation hose from the tire valve.
- Drive the vehicle forward or backward about 10 meters so that the sealant can distribute itself inside the tire.
- Screw the tire inflation hose of the air compressor firmly onto the tire valve again and repeat the inflation process.
- If the required tire inflation pressure is still not reached, the tire is too severely damaged. The tire cannot be sealed with the tire repair kit. Do not continue driving. Seek professional help ⇒
.
- Disconnect the air compressor and unscrew the tire inflation hose from the tire valve.
- Once a tire inflation pressure of 2.0 – 2.5 bar (29 – 36 psi / 200 – 250 kPa) has been reached, drive on immediately at a maximum of 80 km/h.
- Check the tire inflation pressure after driving for 10 minutes ⇒ Check after 10 minutes of driving.
The tire inflation hose and the air compressor can become hot during inflation.
- Protect hands and skin from hot components.
- Do not place the hot tire inflation hose or the hot air compressor on flammable materials.
- Let the device cool down thoroughly before stowing it.
- If the tire cannot be inflated to at least 2.0 bar (29 psi / 200 kPa), the damage is too severe. The sealant is not able to seal the tire. Do not continue driving. Seek professional help.
Switch off the air compressor after 8 minutes of operation at the latest to prevent overheating! Before switching it on again, let the air compressor cool down for several minutes.
Was this page helpful?