Alerta de colisión en ángulo muerto Fallos y limitaciones

Si la alerta de colisión en ángulo muerto no funciona correctamente, puede aparecer el mensaje de advertencia «Revise el sistema de seguridad en ángulo muerto» ypuede encenderse una luz de advertencia en el cuadro de instrumentos. Haga revisar el vehículo por un concesionario oficial HYUNDAI.

Si el indicador del retrovisor exterior no funciona correctamente, puede aparecer el mensaje de advertencia «Revise la luz indicadora del retrovisor exterior» ypuede encenderse una luz de advertencia en el cuadro de instrumentos. Haga revisar el vehículo por un concesionario oficial HYUNDAI.

Si el radar de ángulo trasero está bloqueado o cubierto, o si el parachoques trasero detrás del radar de ángulo trasero o del sensor está cubierto por algún material extraño, como nieve, lluvia o barro, o si se ha instalado un remolque o un portabicicletas, la capacidad de detección puede reducirse y la alerta de colisión en ángulo muerto puede limitarse o desactivarse temporalmente.

El sistema de seguridad en ángulo muerto se desactiva. Puede aparecer el mensaje de advertencia «Radar bloqueado» en el cuadro de instrumentos.

La función vuelve a funcionar con normalidad cuando se retira dicho material extraño, el remolque o el portabicicletas, y se vuelve a arrancar el motor.

Si la función no funciona con normalidad después de retirar lo que cubría o bloqueaba los sensores, haga revisar el vehículo por un concesionario oficial HYUNDAI.

ADVERTENCIA

• La alerta de colisión en ángulo muerto puede no funcionar correctamente aunque no aparezca ningún mensaje de advertencia ni se encienda ninguna luz en el cuadro de instrumentos.
• La alerta de colisión en ángulo muerto puede no funcionar correctamente en espacios abiertos donde no se detectan objetos (por ejemplo, un aparcamiento vacío) o cuando los sensores se bloquean justo después de arrancar el motor.
• Always disable the Blind-Spot Collision Warning when towing a trailer or using a towing device.

Blind-Spot Collision Warning Limitations

Warning

The Blind-Spot Collision Warning may not operate normally or may activate unexpectedly if:

• Condiciones meteorológicas adversas, como nevadas intensas, lluvia fuerte, etc.
• The rear corner radar or the area around the rear corner radar is covered with snow, water, or dirt.
• The rear corner radar or the area around the rear corner radar is blocked by a vehicle, wall, or pole.
• The temperature around the rear corner radar is very hot or cold.
• You are driving on a highway or through a toll gate.
• The road surface (or the ground near your vehicle) contains metal components (e.g., due to subway construction).
• Stationary objects are near your vehicle, such as sound barriers, guardrails, median dividers, entrance barriers, street lights, signs, tunnels, walls, etc.
• You are driving on a narrow road where trees or grass are overgrown.
• You are driving in a large open area with few vehicles or structures (e.g., desert, meadow, empty parking lot).
• You are driving on a wet road.
• Another vehicle is following very closely behind your vehicle or passing your vehicle at close range.
• Another vehicle is moving so fast that it passes your vehicle in a short time.
• Your vehicle is overtaking another vehicle.
• Your vehicle is changing lanes.
• Your vehicle accelerates at the same time as a vehicle next to you.
• A vehicle in the adjacent lane is two lanes away from you, or a vehicle moves two lanes toward the next lane.
• A vehicle with a trailer or towing device is installed and blocks the rear corner radar.
• The area around the rear corner radar is covered by objects such as a bumper sticker, bumper guard, bike rack, etc.
• The bumper around the rear corner radar has been damaged or modified, and the radar is not in the correct position.
• The height of your vehicle is lower or higher than normal due to heavy loads, abnormal tire pressure, etc.

The Blind-Spot Collision Warning may not operate normally or may operate unexpectedly when the following objects are detected:

• Motorcycle or bicycle
• Vehicle such as a flatbed trailer
• Large vehicle such as a bus or truck
• Moving obstacle such as a pedestrian, animal, shopping cart, or baby stroller
• Low-height vehicle such as a sports car

ADVERTENCIA

• Driving on Curves

The Blind-Spot Collision Warning may not detect a vehicle in the adjacent lane when driving on curves and may not activate the warning.

Always check road conditions and, if necessary, take appropriate measures to drive carefully.

The Blind-Spot Collision Warning may detect a vehicle in the same lane when driving on curves and activate the warning.

Always check road conditions and, if necessary, take appropriate measures to drive carefully.

• Driving where the road merges or diverges

The Blind-Spot Collision Warning may not detect a vehicle in the adjacent lane when the road merges or diverges and may not activate the warning.

Always check road conditions and, if necessary, take appropriate measures to drive carefully.

• Driving on Hills

The Blind-Spot Collision Warning may not detect a vehicle in the adjacent lane, or may misidentify the ground or another object, when driving on hills, and may activate the warning.

Always check road conditions and, if necessary, take appropriate measures to drive carefully.

• Driving where lane heights differ

The Blind-Spot Collision Warning may not operate correctly when driving where lane heights differ. The function may not detect a vehicle on a road with different lane heights (underpass connection area, elevated divided intersections, etc.) and may not activate the warning.

Always check road conditions and, if necessary, take appropriate measures to drive carefully.

ADVERTENCIA

• The Blind-Spot Collision Warning may not operate normally if there is interference from strong electromagnetic waves.
• The Blind-Spot Collision Warning may not operate for 3 seconds immediately after the vehicle is started or when the rear corner radars are initializing.