Body

Cupholder, Removing and Installing

~2min read

Cupholder, Removing and Installing

Removing

- Remove the center console. Refer to → Chapter "Center Console, Removing and Installing".

- Remove the storage compartment in the center console. Refer to → Chapter "Front Center Console Storage Compartment, Removing and Installing".

- Remove the screws -2-, -3- and then remove the cupholder -1- downward.

A68-10470

Trim, Removing

- Remove the screws -1 through 6- and the bracket -7-.

A68-10549

- Lift the retainers -3- by the bottom using a small screwdriver and push the trim in direction of -arrow- at the same time.

- Remove the trim -1- from the cover.

Installing

Install in reverse order of removal. Note the following:

- Attach the trim mounts -2 and 4- to the cover.

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Center Console".

A68-10471

Cupholder, Removing and Installing, Market-Specific

Removing

- Remove the center console rear trim. Refer to → Chapter "Center Console Rear Trim, Removing and Installing".

- Remove the converter with Socket, 12 V-230 V bracket.

- Remove the bolts -arrows- and remove the cupholder -2- downward from the trim -1-.

- If the cupholder is replaced:

  • Free up the wiring harness.
  • Remove the cupholder button. Refer to → Electrical Equipment; Rep. Gr.96; Controls; Overview - Center Console Controls.

Installing

Install in reverse order of removal.

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Center Console".

A68-10598

Center Console Bracket, Removing and Installing

Removing

- Remove the center console. Refer to → Chapter "Center Console, Removing and Installing".

Front Bracket

- Remove the Access/Start System Antenna 1 in Vehicle Interior -R138-. Refer to → Electrical Equipment; Rep. Gr.94; Access/Start Authorization.

- Disconnect and free up the connectors.

- Remove the nuts -1 and 2-.

- Disengage the bracket -3- from the tabs -arrows- for the instrument panel and remove it.

A68-10474

Rear Bracket

- Remove the screws -1, 3 and 4-.

- Remove the bracket -2- from the center console downward.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Center Console".

A68-10550