Body

Magnetic Fields, Setting

~3min read

It Is Necessary to Set the Magnetic Zone If

  • A new Automatic Dimming Interior Rearview Mirror -Y7- is installed.
  • If the vehicle is driven a long distance over more than two zones from the originally set zone, then the new zone must be set again.

Magnetic Zone, Setting

- Press button -2- for six to nine seconds until a "Z" and a magnetic zone number appear.

- Keep pressing the button until the number of the desired zone appears.

- Read desired magnetic zone on the world map:

  • North America.

After a few seconds, the compass display switches from the zone number to the direction.

- The interior rearview mirror automatic dimming function is reactivated after the magnetic zone is set. Refer to → Chapter " Compass Display, Switching On and Off".

A68-10769

Digital Compass, Calibrating

It Is Necessary to Calibrate the Digital Compass If

  • The compass directions are not correct,
  • The letter "C" instead of a direction will appear or the display will be blank.
  • A new Automatic Dimming Interior Rearview Mirror -Y7- is installed.

The Digital Compass May Also Need to Be Calibrated If

  • the vehicle battery was reconnected after being disconnected for an extended period,
  • A new audio system or audio system component was installed.

Digital Compass, Calibrating

- Turn on the ignition.

  • The letter "C" must appear in the compass display -1-.

- If the letter "C" does not appear, press button -2- for 9 to 12 seconds until the "C" appears in the compass display.

- Drive in a circle two to three times at about 10 km/h until a direction is shown in the compass display.

- The interior rearview mirror automatic dimming function is reactivated after the calibration is complete. Refer to → Chapter " Automatic Dimming Function, Switching On and Off".

A68-10769

Automatic Dimming Interior Rearview Mirror, Setting to LHD

It is necessary to set to LHD when:

  • A new Automatic Dimming Interior Rearview Mirror -Y7- is installed.

- Press the button -2- for 12 to 15 seconds until an "L" (for LHD vehicles) appears.

- Press the button again; the drive side will be changed.

- The interior rearview mirror automatic dimming function is reactivated after the calibration is complete. Refer to → Chapter " Automatic Dimming Function, Switching On and Off".

A68-10769

Zones, Reading in World Maps

North America

North America

Automatic Dimming Interior Rearview Mirror, Checking Function

To check function, following conditions must be fulfilled:

  • Interior rearview mirror installed.
  • Ignition switched on.
  • Reverse gear not engaged.
  • Automatic-dimming function must be switched on, indicator light must come on.

Test Sequence

- Cover the photosensor -1- on the housing side.

- Shine a light source, such as a flashlight, on the mirror side of the photosensor -2-.

  • The interior rearview mirror must dim within a short period of time.
A68-10770

Special Tools

Special tools and workshop equipment required

  • Hex Ball Socket -T10058-
W00-11195
  • Wedge Set -T10383-
W00-11251
  • Locking Pin (3 pc.) -T40011-
W00-11267
  • Hook Tool -T40207-
W00-11555
  • Omega Clip Tool -T40280-
W00-11540
  • Angled Screwdriver -VAS6543-
W00-10740
  • Pry Lever -80-200-
W00-11156
  • Trim Removal Wedge -3409-
W00-11118