BMW 1 Quiz
Suspension and Steering

Strut Disassembly

In this manual: Suspension and Steering
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read
010203040502518N·mlb·ft
Tightening torque found on this page

Installation of the rear shock absorber and coil spring is performed in the same way as installation of the front shock absorber and coil spring. Refer to Strut/Shock Absorber Disassembly and Coil Spring Removal and Installation.

PROCEDURE

1. When assembling the rear strut, make sure the threaded stud (1) of the mount is level with the hole in the rubber mount (2) and opposite the bushing.

2. Затяните гайку крепления опоры на штоке амортизатора моментом 25 Нм

2. Tighten the mount nut on the shock absorber piston rod to the torque of 25 N·m.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.