Chevrolet Captiva Quiz
Vehicle Care

Brake Fluid

In this manual: Vehicle Care
Introduction — 1In Brief — 23Keys, Doors, and Windows — 12Seats and Restraints — 17Storage — 4Instruments and Controls — 34Lighting — 8Infotainment System — 14Climate Controls — 4Driving and Operating — 38Vehicle Care — 42Service and Maintenance — 7Technical Data — 3OnStar — 3
~3min read

The brake master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview on page 10-4 for the location of the reservoir.

There are only two reasons why the brake fluid level in the reservoir might go down:

  • The brake fluid level goes down because of normal brake lining wear. When new linings are installed, the fluid level goes back up.
  • A fluid leak in the brake hydraulic system can also cause a low fluid level. Have the brake hydraulic system fixed, since a leak means that sooner or later the brakes will not work well.

Do not top off the brake fluid.

Adding fluid does not correct a leak.

If fluid is added when the linings are worn, there will be too much fluid when new brake linings are installed. Add or remove brake fluid, as necessary, only when work is done on the brake hydraulic system.

Add brake fluid only when work is done on the brake hydraulic system.

When the brake fluid falls to a low level, the brake warning light comes on. See Brake System Warning Light on page 5-16.

What to Add

Use only new DOT 3 brake fluid from a sealed container.

Always clean the brake fluid reservoir cap and the area around the cap before removing it. This helps keep dirt from entering the reservoir.

  • Using the wrong fluid can badly damage brake hydraulic system parts. For example, just a few drops of mineral-based oil, such as engine oil, in the brake hydraulic system can damage brake hydraulic system parts so badly that they will have to be replaced. Do not let someone put in the wrong kind of fluid.
  • If brake fluid is spilled on the vehicle's painted surfaces, the paint finish can be damaged. Be careful not to spill brake fluid on the vehicle. If you do, wash it off immediately.
Brake fluid is a critical component of the braking system in the 2014 Chevrolet Captiva, responsible for transmitting hydraulic pressure from the brake pedal to the brake calipers or wheel cylinders, resulting in brake application. The proper functioning of the brake fluid is crucial for safe and efficient braking performance. Captiva's owner's manual or service guide provides specific recommendations regarding the type of brake fluid to use, typically specifying a DOT (Department of Transportation) brake fluid rating. It's essential to adhere to these recommendations and use the correct type of brake fluid to ensure compatibility with the vehicle's braking system components. Regular inspection of the brake fluid level and condition is recommended as part of routine vehicle maintenance. Over time, brake fluid may absorb moisture from the air, leading to a decrease in its effectiveness and potentially causing brake system malfunction or failure. If the brake fluid appears discolored, contaminated, or if the level is below the minimum mark, it may be necessary to flush and replace the brake fluid according to the manufacturer's recommendations.

Proper maintenance of the brake fluid helps ensure optimal brake system performance, responsiveness, and safety while driving the 2014 Chevrolet Captiva. Following the manufacturer's guidelines and conducting regular inspections and fluid replacements as needed contribute to reliable braking performance and vehicle safety.

Test yourself

A quick Chevrolet Captiva quiz: every answer comes with an explanation and a link to the manual page.