Installation Procedure

Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-Brazing along the edges of the front wheelhouse panel rear reinforcement as noted from the original panel.

Create a 5 x 18 mm (4/16 x 11/16 in) slot for MIG-Brazing where front wheelhouse front panel and front wheelhouse panel rear reinforcement overlap.

Clean and prepare the attaching surfaces for brazing.

Position the front wheelhouse panel rear reinforcement on the vehicle.

Verify the fit of the front wheelhouse panel rear reinforcement.

Clamp the front wheelhouse panel rear reinforcement into position.

Braze accordingly.

Braze the joint from front wheelhouse panel rear reinforcement to front wheelhouse front panel accordingly.

Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.

Install all related panels and components.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.

Enable the SIR system. Refer to SIR Disabling and Enabling.